Updated BOM


#1

I see the BOM has been updated but where are the m3 screws and the nylon spacer used

Thanks


#2

The M3 screws are for holding the servo (however the servo seems to be under powered for actually rotating the E-Chassis, so it may not be worth the effort to get them or the servo with the current design) and the nylon spacers adapt the motor shaft diameter to the inner diameter of the propeller hole.

E


#3

however the servo seems to be under powered for actually rotating the E-Chassis, so it may not be worth the effort to get them or the servo with the current design.

Has this been documented anywhere else? I haven't heard anything about this and it would've probably saved a bit of money not to get one.