The board doen't work. The HomePlug Connect led doesn't switch on

control-systems
sos
electronics

#1

So until yesterday my rov worked, it had been assembled totally without putting the epoxy. Then I put the epoxy into the Pass-through and today my rov does not work anymore.
The HomePlug connection LED will not turn on and ControlBoard will only turn on the LED1. I thought that it was epoxy on the connector but by checking the voltmeter the voltage comes on the connector.
Does anyone have any help ?? What can it be?
I also noticed that if I’m going to power the BBB with a connector the rov lights but the amperage is equal to 0 on the cockpit.


#2

Try walking through this thread and see if it helps.
https://openrov.yonyx.com/y/conversation/?id=7c5b2d70-eac3-11e4-a42b-bc764e1028dd


#3

I understand that the batteries have been unloaded, thank you very much for the help