Hi together,

do I need a serial number for my ROV and where can I get one?



Its etched on the top/aft side, behind the hole for the up/down thruster. Not easy to see at first but angle it towards the light and you should be able to see it.




Hi Richard,

thank you for answering. I'm manufacturing all parts by myself. Fortunately, I have my own laser cutter. The only parts, I bought, are the controller board, the IMU and the top board for the TENDA.

I have no S/N yet. For cutting the outer shelf, it would be good, to have a S/N. After cutting it is seriously to engrave it.


OK, well I guess its a question for Stackpole et consortes then.....