Openrov 25b Controller bord upload ploblem


#1

I used 7-zip, created OpenROV-05-09-2013.img, and generated the image on 16 GB of microsdhc card using win32 diskimager-v0.9-binary.
ubuntu is moving normally.
8080 and tty(ssh) connection have been performed,rov logon is OK.
OPENROV CONTROLLER BORD 25B does not move and operate.
LED is not turned on and a tilt servo does not move, either.
a trial -- the procedure of http://wiki.openrov.com/index.php/Update_Software -- although manual operation was tried as it is automatic, the following errors come out.
Linking libarduino.a
Linking firmware.elf Converting to firmware.hex compilled in /tmp/tmp.RmPKnftUdQ
uploading firmware from /tmp/tmp.RmPKnftUdQ Setting up uploader
Initiating arduino reset
upload failed, trying again.
Initiating arduino reset
upload failed, trying again.
Initiating arduino reset
upload failed, trying again.
Initiating arduino reset
upload failed, trying again.
Initiating arduino reset
upload failed, trying again.
Initiating arduino reset
upload failed, trying again.
Initiating arduino reset
upload failed, trying again.
Initiating arduino reset
upload failed, trying again.
Initiating arduino reset
upload failed, trying again.
firmware-upload.sh: Failed to upload after numerous tries. Aborting.
firmware-installfromsource.sh: Uploading Firmware Failed!
Abortingrov@OpenROV:/opt/openrov$
rov@OpenROV:/opt/openrov$
How does it solve?
please advice.
Tomio Sugiura


#2

1. Ensure your using the 2.5 board software (beta):

http://openrov.com/forum/topics/beta-of-the-controller-board-2-5-aw...

I just pushed some tweaks for the 2.5 board including disabling the RESET that was causing firmware uploads to fail of SPI... which will break cape based boards for the moment... again, all in the 2.5board BETA.