Caps for the electronics bottle?


#1

Hi,

Do you guys have any suggestions about how to obtain/make the caps that seal the electronics acrylic tube? Did you make them yourselves or did you purchase them? I don't think this will be easy to laser cut, so I am wondering what was your solution.

Thanks,

Petr


#2

From the pictures, it looks like you cut out a set of two circular flanges from acrylic a bit smaller in radius than the radius of the pipe housing the electronics and sealed it with insulating rubber bands on the outside of the flanges. Then you glued an additional larger flanges to the individual inner flanges to make them easy to remove. Is that what you did (if it makes any sense)?

Thanks,

Petr


#3

Hi Petr, did you get this figured out?

E